ツキネコ様 英文カタログ
35/45

YTILACEPS● Gold leaf, powder, and glitter can be used to embellish a stamp design.● Once dried, it will become colorless and transparent.● Heating is not necessary. Air drying is recommended.● For non-absorbent materials, please leave for 2-3 days or dry with a hair dryer, etc. (for heat-resistant materials).● Once the glue has dried slightly, place the metallic leaf onto it. Then, cover it with a piece of paper and press down. Wait a few moments before gently removing any excess with a brush.● Be sure to test whether the material to be used will adhere before use.● Before use, ensure to test whether the material to be used will adhere properly.● For the best results, use extra-fine glitter. Larger granules can be harder to adhere.● High absorbent paper is not recommended because it is not sticky enough to adhere the gold leaf, etc.● The pad hardens when it dries out. If this happens, soak it in water, rinse off the glue, and let it dry completely before replenishing the glue.● To prevent drying out, close the lid immediately after use. When storing, close both the inner and outer lids. It is convenient to adhere the inner and outer lids together.● Please use dedicated glue for refilling.Usage:● First, apply the necessary amount of glue to the pad according to the size of the stamp. There is no need to apply it every time.● To apply the gold leaf, place it on the stamped area. Then, put a piece of paper on top and press down with a sponge or similar tool. Wait a bit and let it dry before gently removing any excess leaf with a brush.❶ laitnessE ehT分I❷❸l daP euGGNISSOBMEDAPPMATSneP SSOBMEkraMasreV elzzaD kraMasreV15-60Gold leaf, glitter, and powder can be used to achieve the appearance of a stamp. These materials are easy to use and do not require heat.UsageTo use the glue pad, start by dispensing an appropriate amount of glue and spreading it evenly across the pad.Glossy paperCardstockDrying timeApproximately 15 minutes with absorbent paper and around 60 minutes with less absorbent paper to dry, although this may vary depending on the material, climate, and other conditions.Next, stamp onto the desired surface to transfer the glue. the stamped image to prevent static electricity.3. After the glue is dry, remove any excess leaf with a brush.Gold leafing with stampTo create a stamped image with a finish similar to gold leaf, follow these steps:1. Apply glue evenly then stamp on to the paper.2. Use a tool such as tweezers to press the leaf onto Once the glue has been transferred, sprinkle glitter onto the stamped area and allow it to dry. Finally, remove any excess powder for a clean finish.35The Essential Glue PadGP-000-002● 1 color● package size W138×D70×H20mm● pad size 76×47mm● Glue 15ml● Pad & Glue set with clear caseThe Essential Glue PadInkerRP-000-002● 1 color● W37×D19×H67mm● capacity 15ml

元のページ  ../index.html#35

このブックを見る